Please read ALL of the text below before downloading...
The download link is at the bottom of the page.
PLEASE READ / WARNING / NOTICE / ATTENTION!!!
If you receive errors in the Light-O-Rama software (S3) visualizer from loading an object created by this (LOROC) utility, please do not contact Light-O-Rama or trouble them with issues that are caused by an object created from LOROC.
If your visualizer is running slowly due to too many lights, then you need to create objects with fewer lights. This can easily be done within LOROC by increasing the light spacing (pixel space) amount before tracing an object. While it may look very good to have many lights to get a more realistic image, you have been warned that too many lights will eat up CPU and memory resources. If you crash the visualizer or your system due to this, please do not complain on the boards or at all as you have been warned. Just increase the light spacing to decrease the total number of lights. In the “Object Controls” tab, you can just lower the “Number of Lights” per string.
I hope this tool will be of use to you and I want to make sure you do not unnecessarily complain to Light-O-Rama about issues with their software as they have done a lot of hard work to make an incredible piece of software and this tool is not provided or supported by them.
Thanks,
Shannon aka cyberfix
Introduction:
Light-O-Rama Object Creator (LOROC) is a program to create spiral trees, Weber spiral trees and convert clipart to decorations for the Light-O-Rama S3 or later software.
NOTE: Requires Microsoft .NET v4.0 to be installed. You can download and unpack the ZIP package and then run "setup.exe" to have the software check for prerequisites before continuing the installation.
LOROC Manual
LOROC ManualLOROC-help
LOROC-help.pdf Adobe Acrobat document [555.7 KB]
LOROC Installer
LOROC ZIP Package